Production of the injection block
When the multi-functional tape has opened and the joint is closed, the Hanno injection block can be injected into the multi-functional tape.
Select the appropriate points/areas where the injection block is to be placed. Make sure that the window reveal in these areas is solid and load-bearing to take the loads from the window.
Inject the amount of resin required for the joint width distributed over at least three injections at intervals of approx. 15 mm. Please determine the required amount of resin for spacer blocks and load-bearing support blocks with the Statics and Injection Quantity Tool or for spacer blocks without required load transfer with the help of the following tables.
Note: If you do not know which table is the correct one, simply compare the tape size of your tape with the bsizes from the tables.
- Hanno-3E Tapes18 KB
- Hanno-3E BG121 KB
- Hanno-3E Easy20 KB
- Hanno-THERM18 KB