Hanno®-Injektionsklotz
The HANNO product world
Product description
Hanno® injection block is a PU injection resin for selective injection into joint sealing tapes.
Product properties
- Compressive strength after curing and suitable for load transfer
Application areas
- When installing windows to support loads from their own weight, payloads, and other loads that occur with windows and doors, for example, for pressure-resistant backing of fittings when burglary resistance is required.
Processing
The injection is made directly into the fully installed joint sealing tape; it is not necessary to unclip the tape before installation. The joint must be closed. Suitable for pre-compressed joint sealing tapes and multifunctional sealing tapes made of polyurethane soft foam with acrylate dispersion impregnation. Please refer to our installation instructions.
Cleaning
- Clean tools only while the product is still uncured using a standard PU spray gun cleaner. After skin contact, wash off with water and rinse thoroughly.
Delivery form
- Delivered in standard construction cartridges (300 ml) and processed using standard cartridge presses (with a maximum transmission ratio of 18:1).
Download area
| Data sheet "Hanno®-Injektionsklotz" | ||
|---|---|---|
| German version | 880 KB | |
| English version | 878 KB | |
| Property | Standard | Value |
|---|---|---|
| Color | - | Farblos, zähflüssig |
| Density | - | ca. 1,13 g/cm³ |
| pressure absorption |
|
1 mm: 2,9 N/mm², ift* 2 mm: 8,4 N/mm² 3 mm: 11,6 N/mm² |
| Suitability for use: Load transfer/lateral position securing | MO-02/1 | erfüllt |
| dimensional stability | - | ≤ 3 mm (42d, 60 °C, 2,9 N/mm²), ift* |
| Driving rain tightness | DIN 18542 | > 600 Pa, MPA** |
| Air permeability | DIN 18542 | a<0,1, MPA** |
| Fire behavior |
DIN EN 13501 DIN 4102 |
E, in Prüfung MPA** B1, orientierender Nachweis, MPA** |
| burglary resistance | DIN EN 1627 | RC 2 & RC 3, PIV*** |
| curing time |
|
nach 24 h tragfähig ausgehärtet (23 °C) bei 5 °C nach 48 h tragfähig ausgehärtet |
| Temperature resistance | - | -40 °C bis +100 °C, kurzzeitig bis 130 °C |
| Processing temperature | - | 5 °C bis 40 °C (kaltes Injektionsharz erwärmen auf 15-20 °C, warmes Injektionsharz ggfs. kühlen) |
| Storage stability | - | 12 Monate, trocken in ungeöffneter Originalverpackung zwischen +5 und +25 °C |
| Footnote_(*) | - | * ift Rosenheim |
| Footnote_(**) | - | ** Materialprüfanstalt Hannover |
| Footnote_(***) | - | *** Prüfinstitut Schlösser und Beschläge Velbert |