Hanno®-Folienband DUO Easy 240

Processing

It must be ensured that there is no separating film on the surface to be bonded, e.g. due to moisture, grease or dirt etc., which prevents the adhesive from coming into contact with the surface. surface. Adhesion to the respective substrate must be ensured by carrying out your own tests. The substrate must have sufficient load-bearing capacity and provide an provide a sufficient adhesive base. A spray primer can be used for highly absorbent substrates and to support adhesion on cold damp surfaces. can be used. We recommend the spray adhesive Fast drying from Bowcraft. Hanno®-flashing tape DUO Easy 240 can also be used at low temperatures down to -10 °C. It must be ensured that there is no separating film on the surface to be bonded, e.g. due to moisture, ice or hoar frost etc., preventing adhesive contact with the surface. The full adhesive strength is achieved after thawing to > 0 °C. The additional adhesive strip of Hanno®-flashing tape DUO Easy+ 240 can be processed at ≥ +5 °C. Low temperatures can reduce adhesion. The dwell time, during which the bond cannot be loaded, is extended accordingly. Sufficient adhesion should be ensured by carrying out your own tests before further processing. It is recommended to preheat flashing tape to +15 °C to +25 °C at low temperatures before processing. +15 °C to +25 °C before processing. Unroll Hanno®-flashing tape DUO Easy 240 and cut to length with approx. 5 cm excess length. Remove the cover film and carefully press the fixing strip onto the back of the window. Repeat this process on all sides of the window to be sealed of the window to be sealed, both for the inner and outer seal. Then align the window element, fix it in place, remove the remaining masking film, stick it to the masonry onto the masonry and press down firmly over the entire surface. No additional adhesive is required for bonding to the masonry substrate. Glue overlapping joints. The installation instructions supplied with the product must be observed. Any gaps can be glued with Hanno®-3E foil adhesive MS, for example. Fill the cavity between the window and wall with insulating material, e.g. Hanno® gun foam. In the reveal area, ensure sufficient sufficient fabric reinforcement of the plaster.