Hanno®-Folienband FA Easy 240

Processing

It must be ensured that there is no separating film on the surface to be bonded, e.g. due to moisture, grease or dirt etc., which prevents the adhesive from coming into contact with the surface. surface. Adhesion to the respective substrate must be ensured by carrying out your own tests. The substrate must have sufficient load-bearing capacity and provide an provide a sufficient adhesive base. A spray primer can be used for highly absorbent substrates and to support adhesion on cold damp surfaces. can be used. We recommend the spray adhesive Fast drying from Bowcraft. Hanno® flashing tape FA Easy 240 can also be used at low temperatures down to -10°C. It must be ensured that there is no separating film on the surface to be bonded, e.g. due to moisture, ice or hoar frost etc., preventing adhesive contact with the surface. The full adhesive strength is achieved after thawing to > 0°C. The additional adhesive strip of Hanno®-flashing tape FA Easy+ 240 can be processed at ≥ +5 °C. Low temperatures can reduce adhesion. The dwell time, during which the bond cannot be loaded, is extended accordingly. Sufficient adhesion should be ensured by carrying out your own tests before further processing. It is recommended to preheat flashing tape at low temperatures to +15 °C to +25 °C before processing. Unroll Hanno®-flashing tape FA Easy 240 and cut to length with approx. 5 cm excess length. Remove the cover foil and carefully carefully to the back of the window. Repeat this process on all sides of the window to be sealed. Then align and fix the window element, remove the remaining masking film, stick it to the masonry and press down firmly over the entire surface. No additional adhesive is required for bonding to the masonry substrate. Glue overlapping joints. The installation instructions enclosed with the product must be must be observed. In the case of horizontal foil surfaces, e.g. when used as a "second water-bearing level", a sufficient gradient must be ensured in order to guarantee controlled drainage of water and avoid standing water. Joints should be avoided and corner should only be folded without cutting into the foil and re-glued with Hanno®-3E foil adhesive MS, as the execution quality of such butt joints on the construction site often does not meet the requirements of the classification for resistance to water penetration according to DIN EN 1928 W1. Any imperfections can be glued with Hanno®-3E Foil Adhesive MS, for example. Fill the cavity between the window and the wall with insulation material, e.g. Hanno® gun foam. Ensure sufficient fabric reinforcement of the plaster in the reveal area. For airtight interior sealing, we recommend → Hanno®-flashing tape FI-D or → Hanno®-flashing tape FI Easy 240.